1959 Pan wring

front terminal board

All Panhead related discussions, questions etc.
Post Reply
neilw
Member
Posts: 352
Joined: Sat Dec 20, 2008 3:24 am
Bikes: 1995 Roadking(still brand new)
1991 HD springer
1959 pan (I'm reassembling)
1991 BMW 75RT.
Location: Calgary
Has thanked: 91 times
Been thanked: 18 times

1959 Pan wring

#1

Post by neilw »

I think it was mentioned a few years ago that the terminal board on the front should have the wires connecting to it on the back , not the front . Can someone confirm this ?
Top
nifty
Senior Member
Posts: 591
Joined: Wed Apr 29, 2020 8:24 am
Bikes: 68 FL
Location: Nambour Qld Australia
Has thanked: 256 times
Been thanked: 477 times

Re: 1959 Pan wring

#2

Post by nifty »

Did you look in appropriate service manual?
Did you look in the Knowledge Base?
Did you use the search function?
Given the design of the stainless covers, how do you think it would work?
try this https://www.hydra-glide.net/phpBB3/view ... =62&t=1460

Nifty
Top
panheadrider1961
Senior Member
Posts: 609
Joined: Tue Feb 21, 2017 12:32 am
Bikes: 1961 fl 1976 fxe
Location: macon georgia
Has thanked: 83 times
Been thanked: 193 times

Re: 1959 Pan wring

#3

Post by panheadrider1961 »

Both front and back are used in on one side out on other specific schematic with your motor should be followed i.e. police has extra wiring
Top
nifty
Senior Member
Posts: 591
Joined: Wed Apr 29, 2020 8:24 am
Bikes: 68 FL
Location: Nambour Qld Australia
Has thanked: 256 times
Been thanked: 477 times

Re: 1959 Pan wring

#4

Post by nifty »

Panheadrider1961
Poster states 59, which has a separate headlight and stainless covers, terminals face to rear so they can be accessed via 3 screws and RH rear panel, without removing headlight and front cover.
60up switched to terminals facing front so they can be accessed from front after removing lamp unit of aluminum nacelle.

Nifty
Top
Post Reply

Return to “Panhead”