sprocket shaft spacer
-
- Site sponsor
- Senior Member
- Posts: 653
- Joined: Sun Oct 17, 2010 1:00 am
- Bikes: 1995 fxsts,1963 fl project in progress
- Location: Patten,maine
- Has thanked: 120 times
- Been thanked: 98 times
sprocket shaft spacer
I'm going to run a BDL primary belt on my 63. Is there a standard spacer that goes between the pulley and main bearing seal and spacer?
-
- Senior Member
- Posts: 5327
- Joined: Tue Oct 31, 2017 1:00 pm
- Bikes: 1950 Panhead, Resto-Mod
1968 90", 5 Speed Shovelhead,
1984 Home Built Custom Evo 100" Bagger - Location: Knoxville, Tennessee
- Has thanked: 2801 times
- Been thanked: 2158 times
Re: sprocket shaft spacer
The spacers come in many differing lengths and must be chosen to place the front pulley inline with the clutch shell's pulley depending on what mainshaft you have in your transmission. Only upon assembly, alignment, and measurements can any of this be determined.
I also had to enlarge the transmission's mounting plate holes to steer the rear of the tranny to true the belt's run. It's all cut & try.....
....RooDog....
I also had to enlarge the transmission's mounting plate holes to steer the rear of the tranny to true the belt's run. It's all cut & try.....
....RooDog....