I see these available all over the place, but they all look like the same one, and I can't find any published information on the inner diameter of the "cup" the collar sits on. I saw in the KB, I think, that someone machined one to fit big twin retainers, but I don't have a lathe.
Thanks
Jim
Installed Valve Spring Height Micrometer
One that fits into BT collars
-
- Senior Member
- Posts: 1433
- Joined: Thu Mar 26, 2020 5:46 pm
- Bikes: Rigid Panhead bobber, 68 Shovelhead, 2000 Road King Police bike, 2000 Dyna Wide Glide
- Location: Rhode Island
- Has thanked: 997 times
- Been thanked: 711 times
-
- Senior Member
- Posts: 591
- Joined: Wed Apr 29, 2020 8:24 am
- Bikes: 68 FL
- Location: Nambour Qld Australia
- Has thanked: 256 times
- Been thanked: 477 times
Re: Installed Valve Spring Height Micrometer
Can't answer your question, but...
The last part of this video shows doing it with a snap gauge
Before that everyone used depth gauge or steel ruler
Nifty
The last part of this video shows doing it with a snap gauge
Before that everyone used depth gauge or steel ruler
Nifty
-
- Senior Member
- Posts: 2085
- Joined: Fri Sep 21, 2007 3:03 am
- Bikes: '52 FL
'64 FLH - Has thanked: 164 times
- Been thanked: 513 times
Re: Installed Valve Spring Height Micrometer
Jim:
If you buy one and it doesn't fit, you can send it to me and I'll throw it on the lathe for you. No charge.
If you buy one and it doesn't fit, you can send it to me and I'll throw it on the lathe for you. No charge.