Clutch

Post Reply
Nigel
Member
Posts: 63
Joined: Sun Oct 09, 2016 7:18 pm
Bikes: 1956. Panhead 1980 shovelhead
Location: England
Been thanked: 3 times

Clutch

#1

Post by Nigel »

Hi all thinking of putting 3 1/2 plate clutch with spring plate back in my bike instead of 5 plate wondered on what people’s thoughts were on this thanks for any replys 👍🏻
Little Stan
Member
Posts: 121
Joined: Fri Dec 18, 2015 6:50 pm
Bikes: 1958 FL 1997FXD
Location: Houston, Tx
Been thanked: 42 times

Re: Clutch

#2

Post by Little Stan »

Nigel:

Ran the original 'half plate' style for years and nary a problem even with the studs grooved from wear. Used to think that more grease on the rollers was what your supposed to do but it would start slinging out onto the plates and it would still work but a little rough! I've always had good luck with any big twin clutch new and old, they all work if you understand them.

-'lil stan
RooDog
Senior Member
Posts: 5327
Joined: Tue Oct 31, 2017 1:00 pm
Bikes: 1950 Panhead, Resto-Mod
1968 90", 5 Speed Shovelhead,
1984 Home Built Custom Evo 100" Bagger
Location: Knoxville, Tennessee
Has thanked: 2801 times
Been thanked: 2158 times

Re: Clutch

#3

Post by RooDog »

Why are you thinking about making this change? Personally, I believe the more friction surface you have the less spring pressure you need provided you still have enough separation for a clean disengagement. I like the greenish Kevlar discs. Also, it matters if you are using a foot clutcjh, mouse trap, or an "eliminator" cable operated system. Your question really leaves a lot to be desired......RooDog
Post Reply

Return to “Clutch & Mousetrap”