Regulator/timer adjuster mount

Bottom End (crankcases and crankshaft)
Post Reply
Trogg
Member
Posts: 56
Joined: Sat Nov 07, 2015 1:41 am
Bikes: flh 1959, 850 Commando, 50 Inter, 2 x ES2's, Model 7, Bsa sloper, Triumph Sprint
Location: Rochford, Essex, UK
Has thanked: 12 times

Regulator/timer adjuster mount

#1

Post by Trogg »

Hi guys
My 1959 case has had the regulator block cut off by a previous owner. I have bought a replacement block that will be welded back on.
Can someone measure a good crankcase and give me some measurements. I can see that it will have to be parallel to the timer base but need the offset. See my attached modified drawing for the required info.
I am slowly getting back to somewhere close to original looking. (Not concours but a stock looking 59 pan that is ridden)

Thanks
Paul
UK
You do not have the required permissions to view the files attached to this post.
1950Panhead
Senior Member
Posts: 2404
Joined: Wed Jul 07, 2010 4:28 am
Bikes: 1950Panhead
Location: USA
Has thanked: 1 time
Been thanked: 366 times

Re: Regulator/timer adjuster mount

#2

Post by 1950Panhead »

3.125"
100_3037.JPG
You do not have the required permissions to view the files attached to this post.
Buddhahoodvatoloco
Site sponsor
Site sponsor
Senior Member
Posts: 1916
Joined: Fri Jul 01, 2011 8:43 pm
Bikes: 1969 FLF
1937 EL
1940 U
Location: san diego
Has thanked: 1475 times
Been thanked: 241 times

Re: Regulator/timer adjuster mount

#3

Post by Buddhahoodvatoloco »

you can't help but appreciate the kindness of some of these gents.
Trogg
Member
Posts: 56
Joined: Sat Nov 07, 2015 1:41 am
Bikes: flh 1959, 850 Commando, 50 Inter, 2 x ES2's, Model 7, Bsa sloper, Triumph Sprint
Location: Rochford, Essex, UK
Has thanked: 12 times

Re: Regulator/timer adjuster mount

#4

Post by Trogg »

You are a gentleman. Thank you
Best regards
Paul
Uk
Post Reply

Return to “Bottom End / Crankcases / Flywheels”