compensating sprocket removal

FL58
Member
Posts: 62
Joined: Thu Nov 28, 2013 5:19 pm
Bikes: duo glide 1958
Has thanked: 2 times
Been thanked: 1 time

Re: compensating sprocket removal

#16

Post by FL58 »

Bigincher
Ok I understand how it works now. Sometimes a good sketch is better than a long speech.
No problem, the engine is on the bench now but I took the compensating sprocket off before removing the
engine from the frame.
Thanks
sincerely
58flh
Former member
Senior Member
Posts: 3332
Joined: Sat Jun 26, 2010 1:54 pm
Bikes: 1958flh 1969sporty,had a knuckle but sold back to original owner
Location: NEW JERSEY
Has thanked: 195 times
Been thanked: 277 times

Re: compensating sprocket removal

#17

Post by 58flh »

FL58--The Jam bar is the piece of steel that I said to cut.-I found it the best way to remove compensaters--& those others that talk of the Jambar Have removed a few,Quite a few!--Make one its simple & last you a lifetime!-Must have TOOL for running chain.---Respectfuly---RICHIE
FL58
Member
Posts: 62
Joined: Thu Nov 28, 2013 5:19 pm
Bikes: duo glide 1958
Has thanked: 2 times
Been thanked: 1 time

Re: compensating sprocket removal

#18

Post by FL58 »

pic2.jpg
pic1.jpg
Hello,
now that the engine is on the bench, before opening it, I have to take off the compensating sprocket shaft, but can't find any clear information on the way to do it.
Do I need a special tool ?
sincerely
You do not have the required permissions to view the files attached to this post.
RUBONE
Moderator
Senior Member
Posts: 8378
Joined: Sat Nov 15, 2008 4:09 am
Bikes: Multiple H-D, Ducati, BMW, Triumph, BSA,...
Has thanked: 478 times
Been thanked: 2933 times

Re: compensating sprocket removal

#19

Post by RUBONE »

The sleeve can be anything form a fairly tight press fit to loose on the splines. The factory tool has thin flanges that hook behind the rim of the sleeve and pulls it off. A bearing separator works well for that task too if you have access to one. Warming the sleeve will help as well. Often the sleeve is stuck with old grit/rust/etc., and soaking beforehand with Kroil or the like will also help. Judicious use of a pair of screwdrivers can achieve removal as well but caution must be used.
FL58
Member
Posts: 62
Joined: Thu Nov 28, 2013 5:19 pm
Bikes: duo glide 1958
Has thanked: 2 times
Been thanked: 1 time

Re: compensating sprocket removal

#20

Post by FL58 »

Thank you Rubone, I'll try with a bearing separator.
sincerely
Post Reply

Return to “Sprockets”