when I got my motor it only had a few bolts holding it together an I bought it as a NEEDS REBUILDING ive done the bottom end an pistons an barrels but now ive stopped .my cases are 62 but the heads seem to be 64 so are external oil fed .ive looked for anyone who has made them fit but cant find anything . I have lathes an milling macines so if someone can point me in the right direction on how to feed the heads oil from my cases or oil pump would be greatfully appreciated
cheers in advance
abit stumped
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Please do not start new topics here, but here: New Panhead and Flathead topics
-
- Junior Member
- Posts: 7
- Joined: Fri Oct 02, 2015 12:29 am
- Bikes: 1962 panhead custom
1988 soft tail
1985 soft tail custom
cb750ko - Location: australia
-
- Moderator
- Senior Member
- Posts: 8413
- Joined: Sat Nov 15, 2008 4:09 am
- Bikes: Multiple H-D, Ducati, BMW, Triumph, BSA,...
- Has thanked: 483 times
- Been thanked: 2958 times
Re: abit stumped
There is lots of info in the Knowledge Base section of this forum. It is a common conversion and can be done several ways. From the plug over the lifter screen, from a tee in the oil pressure switch hole, or out of the cam cover ala Knucklehead. All are discussed in old posts. Use the search function.
-
- Junior Member
- Posts: 7
- Joined: Fri Oct 02, 2015 12:29 am
- Bikes: 1962 panhead custom
1988 soft tail
1985 soft tail custom
cb750ko - Location: australia
Re: abit stumped
thanks for that I found the area and have found what im after . I knew id get the correct info in here
cheers
cheers