oem internal throttle with my super e carb
-
- Member
- Posts: 60
- Joined: Wed May 29, 2013 5:46 am
- Bikes: 1955 FLH panhead stock
1974 ironhead chopper - Has thanked: 1 time
- Been thanked: 1 time
oem internal throttle with my super e carb
picked up a set of two piece bars with the internal throttle set up. heres my question wanna run it with my super e carb with the stock wire cable. i know i need the other pull grip just wondering if it works with the wire cable . anyone ever run this set up .
-
- Member
- Posts: 121
- Joined: Thu Mar 08, 2012 10:08 am
- Bikes: Panhead 1959. Dirt bikes, current 2013 Switchback 73 Norton and 79 Triumph
- Location: Newcastle Australia
- Has thanked: 63 times
- Been thanked: 3 times
Re: oem internal throttle
I originally had a two piece set of bars for my 59. I got a set of original one piece bars but I run an S&S Carb, what I did was buy an S& S throttle and made a sleeve for the bars, I notice that S&S make a sleeve as well, I now run a dual throttle cables as recommended by S&S. I left the original throttle cable wire and internals, all well greased mind you inside the bars.
-
- Junior Member
- Posts: 2
- Joined: Wed Jun 25, 2014 5:34 pm
- Bikes: '01FLHTPI,'96XL1022C,74FX1200,'63FLH
5 pre unit Triumph, 5 A65 BSA, 2 Matchless. - Been thanked: 1 time
Re: oem internal throttle
There are a couple ways to do this. I helped a tech at the dealership where I used to work put an earlier set of internal control bars in a later bike with a Keihin CV carb, essentially what you're looking to do.You will need a pull spiral. He used the late stranded cable and the Keihin's return spring. He tinned the last couple of inches of the cable at the throttle end with solder, then cut the throttle end barrel off so it would fit in the internal control. He also greased the crap out of everything. It worked well on the bench and on the test ride, but I don't know about long term.
If you're looking to use the earlier solid wire and not worried about (or don't want) a spring return, look at the way the cable attached on a Bendix carb. You'll have to fabricate something like that to replace the cable spool on your S&S. HD actually did have a lightweight return spring on the earlier ('71-'73) internal throttle Bendix carbs. It's part # 27272-71. Looks just like the later 27272-74 spring only made from thinner wire. Maybe the Bendix spring will fit on your S&S. Good luck.
If you're looking to use the earlier solid wire and not worried about (or don't want) a spring return, look at the way the cable attached on a Bendix carb. You'll have to fabricate something like that to replace the cable spool on your S&S. HD actually did have a lightweight return spring on the earlier ('71-'73) internal throttle Bendix carbs. It's part # 27272-71. Looks just like the later 27272-74 spring only made from thinner wire. Maybe the Bendix spring will fit on your S&S. Good luck.