front header pipe/frame clamps
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Please do not start new topics here, but here: New Panhead and Flathead topics
-
- Member
- Posts: 348
- Joined: Mon Jul 11, 2011 3:09 pm
- Bikes: "50 FL Panhead, '47 WL, '57 165cc
- Location: Georgia
- Has thanked: 11 times
- Been thanked: 2 times
front header pipe/frame clamps
I have searched this site and a couple of others and haven't gotten a great picture of their correct configurations. I think I have it mostly figured out, just not 100%. I know the smaller clamp mounts to the frame down tube while the other mounts to the pipe and then they bolt together . This is for a '50 so I also know that they mount down low on the front header pipe/below the sidecar loops. Can someone post some closeup photos of how these clamps mount? thanks
-
- Member
- Posts: 348
- Joined: Mon Jul 11, 2011 3:09 pm
- Bikes: "50 FL Panhead, '47 WL, '57 165cc
- Location: Georgia
- Has thanked: 11 times
- Been thanked: 2 times
Re: front header pipe/frame clamps
Wouldn't you know it. I finally found a better picture after posting the question here. Looks like it mounts on frame right behind the brake pedal plate. And the P clamps mount back to back with the bolt head on the pipe side. Here is a simplified "stick" drawing. Look right?
- Attachments
-
- clamps.png (16.61 KiB) Viewed 1296 times
-
- Senior Member
- Posts: 826
- Joined: Tue Nov 18, 2008 7:33 pm
- Bikes: 1952 FL
2020 Honda Super Cub - Location: Estero Florida
- Has thanked: 49 times
- Been thanked: 57 times
Re: front header pipe/frame clamps
Not sure if I understand the configuration, can i get a close up???
Jim
Jim