s&s super e
throttle cable
-
- Junior Member
- Posts: 4
- Joined: Sun Jan 08, 2017 1:37 pm
- Bikes: 65 pan 45 wla 42 wla 56 servi 66 servi 60 servi 51 wl 2002 lowrider
- Location: michigan
s&s super e
i have a s&s super e i want toput on my 69 flh i would like to use the origonal internal handle bar cable any one have ideas
-
- Senior Member
- Posts: 1600
- Joined: Fri Oct 03, 2008 2:57 am
- Bikes: Pan
FLHP Evo
E-H Super X
Chubble head hack
Servi-car
Topper(s)
Model 64D (Hey its got 3 wheels!) - Location: Indianapolis
- Has thanked: 399 times
- Been thanked: 364 times
Re: s&s super e
I recently did exactly this as an exercise... I removed all the springs on the throttle shaft. Then I drilled a hole in the existing throttle cable "wheel" and mounted a stock wire block to accept the solid inner throttle wire. I'll note that while the setup worked, the position of the wire block I chose was not ideal to allow a full smooth travel... and you absolutely do not want something to possibly hang in this location, especially when trying to throttle down!
My final solution was to figure out why my stock Tillotson carb was not functioning properly, and then correct it. The Tillotson
has been a great carb on this bike, especially in comparison to the Super E and a Bendix.
- Attachments
-
- IMG_7448.jpg (58.26 KiB) Viewed 148 times