1959 Pan wring
front terminal board
-
- Member
- Posts: 352
- Joined: Sat Dec 20, 2008 3:24 am
- Bikes: 1995 Roadking(still brand new)
1991 HD springer
1959 pan (I'm reassembling)
1991 BMW 75RT. - Location: Calgary
- Has thanked: 91 times
- Been thanked: 18 times
1959 Pan wring
I think it was mentioned a few years ago that the terminal board on the front should have the wires connecting to it on the back , not the front . Can someone confirm this ?
-
- Senior Member
- Posts: 591
- Joined: Wed Apr 29, 2020 8:24 am
- Bikes: 68 FL
- Location: Nambour Qld Australia
- Has thanked: 256 times
- Been thanked: 477 times
Re: 1959 Pan wring
Did you look in appropriate service manual?
Did you look in the Knowledge Base?
Did you use the search function?
Given the design of the stainless covers, how do you think it would work?
try this https://www.hydra-glide.net/phpBB3/view ... =62&t=1460
Nifty
Did you look in the Knowledge Base?
Did you use the search function?
Given the design of the stainless covers, how do you think it would work?
try this https://www.hydra-glide.net/phpBB3/view ... =62&t=1460
Nifty
-
- Senior Member
- Posts: 614
- Joined: Tue Feb 21, 2017 12:32 am
- Bikes: 1961 fl 1976 fxe
- Location: macon georgia
- Has thanked: 83 times
- Been thanked: 196 times
Re: 1959 Pan wring
Both front and back are used in on one side out on other specific schematic with your motor should be followed i.e. police has extra wiring
-
- Senior Member
- Posts: 591
- Joined: Wed Apr 29, 2020 8:24 am
- Bikes: 68 FL
- Location: Nambour Qld Australia
- Has thanked: 256 times
- Been thanked: 477 times
Re: 1959 Pan wring
Panheadrider1961
Poster states 59, which has a separate headlight and stainless covers, terminals face to rear so they can be accessed via 3 screws and RH rear panel, without removing headlight and front cover.
60up switched to terminals facing front so they can be accessed from front after removing lamp unit of aluminum nacelle.
Nifty
Poster states 59, which has a separate headlight and stainless covers, terminals face to rear so they can be accessed via 3 screws and RH rear panel, without removing headlight and front cover.
60up switched to terminals facing front so they can be accessed from front after removing lamp unit of aluminum nacelle.
Nifty