toolbox
mounting toolbox
-
- Member
- Posts: 14
- Joined: Thu Jul 07, 2016 6:21 pm
- Bikes: 1969xlch; 1977xlh;1976fxe;1998fatboy;1960flh
- Location: iowa
- Been thanked: 2 times
toolbox
I picked up a stock toolbox for my 1960 duo glide at the antique swap meet in Davenport Iowa last summer. Its only a 30 minute drive from my home. How does it mount on the the frame. There is one hole on the frame where it mounts; but where does the other hole on the toolbox go ????
-
- Senior Member
- Posts: 1503
- Joined: Wed May 09, 2001 11:02 pm
- Bikes: 50 EL chopper
44 U that looks like a 37.
60 FLH (Sold)
59 FLH (Sold)
58 FL (Sold)
08 CVO Road King - Location: Maryland
- Has thanked: 243 times
- Been thanked: 137 times
Re: toolbox
You should have 2 threaded holes. There are 2 big flanged washers and oval flat head screws to secure through both holes. This is the best picture I had on hand.
You do not have the required permissions to view the files attached to this post.
Re: toolbox
The tool box should have a smooth cover, with a captive slotted screw. the box mounts to the frame with the narrow side up.
VPH-D
VPH-D
-
- Moderator
- Senior Member
- Posts: 8406
- Joined: Sat Nov 15, 2008 4:09 am
- Bikes: Multiple H-D, Ducati, BMW, Triumph, BSA,...
- Has thanked: 481 times
- Been thanked: 2956 times
Re: toolbox
The lower mount is a cast lug on the lower frame casting above the two holes for the muffler bracket, the upper is in the middle of the tube behind the oil tank. Both are factory threaded to 5/16-24 for the countersunk head bolts.