Pinion gear sizes
-
- Member
- Posts: 22
- Joined: Tue Apr 13, 2010 7:34 am
- Bikes: 1960 FL
- Location: california
Pinion gear sizes
replacing cam original cam had green gear new cam has white gear the pinion gear is not marked but measures to red/brown the difference between my green gear and my pinion gear is greater then the white gear but by the book is still too small for the white can gear. my gear case never whined or made noise to begin with. will this be a problem?
-
- Member
- Posts: 325
- Joined: Thu Jan 07, 2010 5:13 pm
- Bikes: 1941wla,1946el,1947fl,1950fl,1959flh,1972flh,4 twinkies,1 evo
- Location: oregon
- Has thanked: 4 times
- Been thanked: 12 times
Re: Pinion gear sizes
hi, are these andrew cams? if it is, make are referance mark at the key way ,remove both gears,put you old gear on the new cam,by the marks to keyway, they make a wayme jamme tool for this,or send it to andrews. i've done a bunch by the key way mark methed,never had a prob. but only on andrews cams. i beleave that stock press on gears are the same side bore size as andrews ? then you should be the same match as before.hope this helps,or makes things worse....with respect....JR
-
- Inactive member
- Senior Member
- Posts: 521
- Joined: Tue Feb 03, 2009 10:05 pm
- Bikes: 1938U,1949FL,1961FL,1968XL,1979FL ,1958 FL, 1965 BMW,1975 Honda CB750
- Been thanked: 14 times
Re: Pinion gear sizes
If you do not have a noise issue then you really dont have a problem.HD says that ideally you should have a slight gear whine when cold and no noise at all when hot.The cam and pinion gear color codes do not always match but if the cam\pinion gear fitment is correct(no noise) it doesnt matter.A too tight fit makes a whining noise.A too loose fit generally sounds like a ticky front exhaust pushrod(in single cam engines).HTH
-
- Member
- Posts: 22
- Joined: Tue Apr 13, 2010 7:34 am
- Bikes: 1960 FL
- Location: california
Re: Pinion gear sizes
thanks the clearence is actually tighter with the new gear .002 it was .003 with the old green gear and it did not make noise