Crankcase Vent
-
Fast Ed 53
- Inactive member
- Member
- Posts: 119
- Joined: Sat May 31, 2003 8:05 am
- Bikes: -
- Location: So. Illinois
Crankcase Vent
I,m installing a belt system on this bike and I could use some help.What can I do with the vent/primary oiler tube that sticks into the inner cover? I appreciate any info I can get. Thanks, Ed
-
mbskeam
- Senior Member
- Posts: 1014
- Joined: Fri Apr 18, 2003 12:26 pm
- Bikes: *
- Location: Sultan, WASH
- Been thanked: 6 times
- Contact:
Re: Crankcase Vent
I cut mine off and welded it 90 deg. so that it points down(flat to the case) Then I hooked a hose to it, so as to breath on the rear chain.So that the oil mist will oil the chain. MB
-
Fast Ed 53
- Inactive member
- Member
- Posts: 119
- Joined: Sat May 31, 2003 8:05 am
- Bikes: -
- Location: So. Illinois
-
panomania
- Inactive member
- Member
- Posts: 95
- Joined: Sat Dec 01, 2001 1:00 am
Re: Crankcase Vent
if you happen to run a s&s oil pump you can virtually cut the oil off without affecting the breathing.