hello
I have a 59 pan which i want to convert to outside oiler heads.Do I block off the feed at the cases and then feed the top end from the tappet screen position.I am not sure.Any advice would be helpfull.
thank you.
outside oiler heads
-
- Inactive member
- Junior Member
- Posts: 2
- Joined: Sun Sep 25, 2011 12:06 pm
- Bikes: 1925 jd
1959 panhead
-
- Site Admin
- Senior Member
- Posts: 3291
- Joined: Mon Jan 01, 2001 12:00 pm
- Bikes: 1954 FL
- Location: Holland
- Has thanked: 108 times
- Been thanked: 488 times
Re: outside oiler heads
And here another topic: https://hydra-glide.net/phpBB3/viewtopic.php?f=5&t=8765
-
- Inactive member
- Junior Member
- Posts: 2
- Joined: Sun Sep 25, 2011 12:06 pm
- Bikes: 1925 jd
1959 panhead
Re: outside oiler heads
Hello.
Panhead,I looked at the other topic you suggested and the way to feed my top end is by using the oil pressure switch port.A bit more info on my situation.I have a set of std heads that are outside and inside oiler,so there are no mods needed to the heads.Do I plug the feed holes at the cases where they feed oil up the barrels and do I plug the feed holes in the heads.If I plug these four holes what is the best way to do this.
Thank you.
Panhead,I looked at the other topic you suggested and the way to feed my top end is by using the oil pressure switch port.A bit more info on my situation.I have a set of std heads that are outside and inside oiler,so there are no mods needed to the heads.Do I plug the feed holes at the cases where they feed oil up the barrels and do I plug the feed holes in the heads.If I plug these four holes what is the best way to do this.
Thank you.
-
- Senior Member
- Posts: 2096
- Joined: Fri May 24, 2002 1:00 am
- Bikes: 64FL 99FLHR 01FXSTD
- Location: Mpls. MN.
- Has thanked: 71 times
- Been thanked: 149 times
Re: outside oiler heads
It would look more "normal" if you just use the holes in the barrels and forget about adding the external lines. Or you could use some Shovel base gaskets to stop the oil and build some external lines.
-
- Senior Member
- Posts: 614
- Joined: Tue Jul 13, 2004 7:04 pm
- Bikes: 1949 FL Chopper
- Has thanked: 5 times
- Been thanked: 37 times
Re: outside oiler heads
These heads are getting ready to go on my panhead. They are the '58 castings that have been modified for outside oil lines. The oil feed hole in the head gasket surface has been welded up and then the surface has been made flat again. The cylinders are unmodified and still have the oil feed hole.
-Craig
-Craig
You do not have the required permissions to view the files attached to this post.