Oil Pump Question
-
- Senior Member
- Posts: 696
- Joined: Sat Jun 05, 2004 5:55 pm
- Bikes: EL, FXE & FLH
- Has thanked: 20 times
- Been thanked: 69 times
Oil Pump Question
Was reading that someone suggested by using a 73 and up oil pump drive gear and pinion worm gear in your stock oil pump you can get a 25% volume increase. Question #1 - good or bad advice? Question #2 - if this is so does it apply to the old cast pumps or to just the later style aluminum pumps.
-
- Member
- Posts: 227
- Joined: Fri Apr 04, 2008 6:25 am
- Bikes: Knucklehead and a Triumph
- Location: North East Kansas
- Has thanked: 36 times
- Been thanked: 5 times
Re: Oil Pump Question
When My Pan Head was being rebuilt the Fella rebuilding the lower end called me and ask me If i wanted the higher volume oil pump gear installed on the S & S oil pump...he told me the added benefits as more pressure at Idle and i said yes.....i have great oil pressure at idle now...so if thats possible for you to Upgrade that oil pump....i sure would.
Motor Cycle Mike*
Motor Cycle Mike*
-
- Senior Member
- Posts: 6937
- Joined: Sun Feb 10, 2002 2:30 am
- Bikes: -
- Location: Central Illinois
- Has thanked: 112 times
- Been thanked: 310 times
Re: Oil Pump Question
Pressure is highly over rated.
That's why there is a by-pass valve;
Turning it faster just means it stays open longer.
...Cotten
That's why there is a by-pass valve;
Turning it faster just means it stays open longer.
...Cotten