Morning Boys,
My sending is leaking around the insulating material and the metal body, is there a way to re seal it or do I need to cut bait and replace it ? If replacing it is required any suggestions on where to purchase one ?
Thanks, Kenny
Oil Pressure sending unit
-
- Former member
- Senior Member
- Posts: 3336
- Joined: Sat Jun 26, 2010 1:54 pm
- Bikes: 1958flh 1969sporty,had a knuckle but sold back to original owner
- Location: NEW JERSEY
- Has thanked: 195 times
- Been thanked: 278 times
Re: Oil Pressure sending unit
There are GOOD VENDERS in the vender section on this site!/--45 depot comes to mind & many others are in there as well!--Respectfully---RICHIE
Re: Oil Pressure sending unit
I'm using the stock factory EVO style switch on two of my Panheads with good results.
VPH-D
VPH-D