Tappet Adjusting Screw Dimension
-
- Member
- Posts: 83
- Joined: Sun Apr 04, 2010 8:01 pm
- Bikes: '80 FLT
'51 FL Bobber - Location: Wisconsin
- Been thanked: 5 times
Tappet Adjusting Screw Dimension
I am on the verge of finishing my '51 pan motor but first I want to replace the tappet adjusting screws. The problem I am running into is that the pocket for the pushrod is too big. The first set was too small with a 5/16" pocket. Now the second set that I ordered has a 7/16" diameter pocket yet my new pushrods has a 3/8" ball. Shouldn't this be a closer fit? Do I now have to find a set of pushrods with a 7/16" ball on both ends? Who makes correct fitting parts?
-
- Senior Member
- Posts: 6938
- Joined: Sun Feb 10, 2002 2:30 am
- Bikes: -
- Location: Central Illinois
- Has thanked: 112 times
- Been thanked: 310 times
Re: Tappet Adjusting Screw Dimension
FL9018!
You have been stung with a set of bad DIXIE's from twenty years ago.
The fit should be perfect, or at least lappable;
Eastern's used to be fine.
....Cotten
You have been stung with a set of bad DIXIE's from twenty years ago.
The fit should be perfect, or at least lappable;
Eastern's used to be fine.
....Cotten