Help timing mallory ignition
-
- Inactive member
- Member
- Posts: 18
- Joined: Sat Jun 26, 2010 7:48 pm
- Bikes: 1964 pan, 1970 honda 100cc, yamaha wr 250f
- Location: New Mexico
Help timing mallory ignition
I just just completed installing a mallory ignition (pn a557) on my 64 pan and I am not sure I have right in time yet, It is still a little hard to start even hot takes a few kicks, when I did get the bike running put a timing light on it the timming mark was bouncing back in forth and got it to what i thought was really close at idle, ran it down the road about three miles it had a little sputter at the start after it idled and looked to be loading up the front cylinder, ran good at higher rpms, got home pulled the plugs the front looked a little rich and the rear was very lean. I don't know what else i should do?