Mallory all electronic ignition distributor and sparks

[ciciomero]

Hi guys,
sorry for my bad inglish .
I'm in the forum for a wile. I write very little but I read very mutch.
I've two quick questions for you:

What do you think about Mallory All electronic ignition distributor? (I bought it)
What kind of sparks do you use with it? (inside there is an accell 35496 how you know)

I hope to resolve my trouble of pinging on head.

Thank you and good road at all!

[fourthgear]

I use a 3 ohm coil ,( you can get away with a point type coil, used one for about a year with no problem ) you want electronic ign. plug wires ( a must or you could damage your ign.) & the plugs you are using are fine ,I'm using Champion RJ12YC plugs with my Mallory . The coil Ohm reading will surpposedly get you better performance ,starting ect..

Hope thats what your asking .Nice Bike!

[ciciomero]

Yes, thank fourthgear
If I'm right RJ12YC are for evo engine. Ok thank again.
OnlY a thing, the last one, can you tell me the gap of the sparks?

[stroker93]

i use a Vulcan single fire distributor in my pan,,so I run a dual dyna coil set up..I do use a spark plug wire designed for an electronic ignition and run NGK plugs designed for a CDI system. Plugs fors points & condenser are not good for an electronic ignition,,,,people will argue it doesn't matter but I've never had an ignition go bad..It also doesn't cost more money,I run all plugs for year and change out every spring.
Dave

[fourthgear]

RJ12YC ( resister plugs for elctronic ign. ) is what I have in my Pan ,I gap them @ .035 in..I don't own an Evo.,I do have a TC88 & I use HD plugs in her.

[oldbob]

I hope to resolve my trouble of pinging on head.

Pinging or spark knock could be from to much advance on timing.

[ciciomero]

I've pingig trouble due to high compression.
I hope that accell 35496 will be able to resolv my trouble . It has 13 advance curve!