I've got a Cycle Electrics 12 volt generator with the same brand regulator fitted to the end. I need a replacement brush cover. Can anyone tell me if it is the same as the brush cover found on the original later style 2 brush generator or do I need to try buy a replacement through Cycle Electrics?
StueyC
Brush cover strap
Forum rules
Please start new topics here: New Panhead and Flathead topics
Please start new topics here: New Panhead and Flathead topics
-
- Inactive member
- Member
- Posts: 201
- Joined: Sat Aug 01, 2009 3:48 am
- Bikes: 60 FL Pan, 2011 Wide Glide, 49 BSA, 40 Ariel, 47 Excelsior (British)
- Location: Australia
-
- Inactive member
- Senior Member
- Posts: 1401
- Joined: Sat Apr 03, 2004 5:54 am
- Bikes: -
- Location: north florida
- Been thanked: 7 times
Re: Brush cover strap
I assume you are talking about the one that just covers the openings of the gen. where the brush's are. I got a chrome one from JP's and I think its the same one for a two brush gen. . An OEM one will probably be black.
-
- Inactive member
- Member
- Posts: 201
- Joined: Sat Aug 01, 2009 3:48 am
- Bikes: 60 FL Pan, 2011 Wide Glide, 49 BSA, 40 Ariel, 47 Excelsior (British)
- Location: Australia
Re: Brush cover strap
Your right Fouthgear, I'm taling about the cover for the brushes. The original Cycle Electric cover had a thick plastic coating that I assume helped seal the unit from water when tightened up. I don't want to buy a replacement only to find it is a different width. I can't find a Cycle Electric P/N in any catalogue.
StueyC
StueyC