Wiring Question
Forum rules
Please start new topics here: New Panhead and Flathead topics
Please start new topics here: New Panhead and Flathead topics
-
- Member
- Posts: 55
- Joined: Tue Dec 11, 2012 11:30 pm
- Bikes: 1958 Panhead motor in a wishbone frame.
- Has thanked: 55 times
Wiring Question
I'm doing a bare minimum wiring on my custom 58 panhead (headlight, dash lights, tail/stop light). How would I wire the gen and oil lights on the dash so they work properly? Is there a wire that goes from the oil pump up to the dash? Do I run a wire from the gen up to the regulator or a wire from the gen terminal to the dash? Thanks
-
- Senior Member
- Posts: 2405
- Joined: Wed Jul 07, 2010 4:28 am
- Bikes: 1950Panhead
- Location: USA
- Has thanked: 1 time
- Been thanked: 366 times
Re: Wiring Question
Use a stock generator harness, there are only three wires.How would I wire the gen and oil lights on the dash so they work properly?
Yes, run a wire from the pressure switch to the oil light terminal in the dash.Is there a wire that goes from the oil pump up to the dash?
Jerry