I read somewhere on the net, that the idle mixture screw on the back of a CV carb, sits in the housing with a spring, washer and O-ring.
I only have the the screw and the spring, no washer, no O-ring. Are these cruzial parts that I am missing?
Does anyone know where I might find a exploded view of the CV? Would be nice to seem if all other parts were in place.
parts missing?
Forum rules
Please start new topics here: New Panhead and Flathead topics
Please start new topics here: New Panhead and Flathead topics
-
- Inactive member
- Senior Member
- Posts: 1400
- Joined: Sat Apr 03, 2004 5:54 am
- Bikes: -
- Location: north florida
- Been thanked: 7 times
Re: parts missing?
Seal may still be in the carb body.Unless you have the carb off ,it will be hard to check. mirror maybe.
-
- Senior Member
- Posts: 2087
- Joined: Fri May 24, 2002 1:00 am
- Bikes: 64FL 99FLHR 01FXSTD
- Location: Mpls. MN.
- Has thanked: 72 times
- Been thanked: 145 times
Re: parts missing?
Henricksonne, do you happen to own any Harley service manuals from 1988 up? They all show several cuts through the cv...Mike
-
- Member
- Posts: 15
- Joined: Tue Sep 14, 2004 10:19 am
Re: parts missing?
carb is off, on the table up-side down, and with a flash light I have checked the no washer and no O-ring is present.
I dont have a service manual, but if anyone knows where I might find an exploded view online, I would appreciate it.
I dont have a service manual, but if anyone knows where I might find an exploded view online, I would appreciate it.
-
- Senior Member
- Posts: 2087
- Joined: Fri May 24, 2002 1:00 am
- Bikes: 64FL 99FLHR 01FXSTD
- Location: Mpls. MN.
- Has thanked: 72 times
- Been thanked: 145 times
Re: parts missing?
Check this out, http://www.johnsmotorcycleparts.com/kei ... images.htm Also check the home page on there to find your missing parts...Mike
-
- Member
- Posts: 15
- Joined: Tue Sep 14, 2004 10:19 am
Re: parts missing?
Sucks.......john doesn't ship overseas!
Can anyone help with the measurements for tha O-ring and the washer. should be able to buy the O-ring through work, the washer I might be able to make by myself.
Can anyone help with the measurements for tha O-ring and the washer. should be able to buy the O-ring through work, the washer I might be able to make by myself.