Good morning, all!
I've tried searching the forum but haven't found a link to this topic. Can anyone point me to a list of the special thread pitches HD used on the Panhead, and their application? I have taps and dies 5/8x18, 3/8x20, 3/8x24, 1/4x24 plus most all of the standards.
Any leads greatly appreciated!
Mike in Mass
Source for list special threads used
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Please do not start new topics here, but here: New Panhead and Flathead topics
-
- Inactive member
- Junior Member
- Posts: 6
- Joined: Sun Mar 30, 2008 6:03 am
-
- Senior Member
- Posts: 1270
- Joined: Fri Jul 03, 2009 8:23 pm
- Bikes: 65 FLH 82 FLH
- Location: Michigan
- Been thanked: 60 times
Re: Source for list special threads used
Spare Parts Manual, 1941-54, pages 207 through 213 under "Misc. Listings are hardeware items (cotter pins, screws and bolts, washers, nuts, rivets, steel balls and grease fittings. These are listed by Pt. # with a discription of each. Example, Pt # 8095, 1-20 N.E.F. x 3/8 x1-3/8 hexagon nut. This is not all inclusive, but covers the years 41-54 which of course is only the early Pan years. Also you will probably have to convert some of these #'s to the new Pt #'s which started about 1950 (just a guess). Hope this helps ya....bosheff
-
- Inactive member
- Junior Member
- Posts: 6
- Joined: Sun Mar 30, 2008 6:03 am
Re: Source for list special threads used
Just, what I was looking for, Bosheff.
Much obliged!
Mike in Mass
Much obliged!
Mike in Mass