Im not a screw/bolt expert so I need to ask. Is the #12 bolt close to the same diameter of the 1/4 inch bolt ??
I'm not worried about the threads being different. I just need to know if they are close to the same diameter.
I'm going to swap out some chrome bolts and nuts for Stainless Steel and I can pick up #12's for free.
Thanx
Randy
#12 & 1/4 inch bolts
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Please do not start new topics here, but here: New Panhead and Flathead topics
-
- Senior Member
- Posts: 6937
- Joined: Sun Feb 10, 2002 2:30 am
- Bikes: -
- Location: Central Illinois
- Has thanked: 112 times
- Been thanked: 310 times
Re: #12 & 1/4 inch bolts
#12 screws are comparable to a 3/16" bolt, and not properly interchangeable with 1/4".
Filister head #12-24 screws are desireable for other things on many vintage machines.
Note that most 1/4" bolt applications on H-D's were 24 tpi. Cross-tapping a hole to 20 or 28 usually ends up helicoil'd back to original, at an annoying expense!
Filister head #12-24 screws are desireable for other things on many vintage machines.
Note that most 1/4" bolt applications on H-D's were 24 tpi. Cross-tapping a hole to 20 or 28 usually ends up helicoil'd back to original, at an annoying expense!
-
- Member
- Posts: 293
- Joined: Sat Sep 14, 2002 8:54 am
- Bikes: -
- Location: Southwestern, Pa.
- Been thanked: 1 time
Re: #12 & 1/4 inch bolts
Thanx Cotten
The 12-24 bolts/nuts are to replace 1/4 inch bolts/nuts in my windshield.
Looks like it'll work just fine.
Thanx again
Randy
The 12-24 bolts/nuts are to replace 1/4 inch bolts/nuts in my windshield.
Looks like it'll work just fine.
Thanx again
Randy