Bestway 5SPCH

All other topics
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Post Reply
VintageTwin
Senior Member
Posts: 1333
Joined: Mon Mar 11, 2002 5:11 pm
Bikes: '46 Knuck. '57 Panhead, '59 Panhead
Location: Repop Hell
Has thanked: 1 time
Been thanked: 9 times
Contact:
Contact VintageTwin

Bestway 5SPCH

#1

Post by VintageTwin »

The rear 2x4x14" support for OHV Big Twins has two 2-1/4" holes core-drilled for rigid and swing arm transmission stud access. Align the 2x4 with the edge of the ramp where yellow corner marks are.
That half-moon hole on the left side of the 2x4 needs the top edge widened back (fluted like, ya' know?) or you can't fit a socket extension up to tighten the right rear trans stud on a rigid frame Big Twin. Also that front 2x4 needs a 6" section cut-down in the middle for skid-pan clearance on a rigid frame. I'm altering mine with the blade depth set on a table saw and making a bunch of relief passes so I can knock out the kerfs like it was routed.
Attachments
BstWy_1.JPG
BstWy_1.JPG (34.47 KiB) Viewed 560 times
Last edited by Anonymous on Mon Nov 14, 2005 3:55 pm, edited 12 times in total.
Top
Post Reply

Return to “General/Miscellaneous topics”