has anyone done a step by step
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Please do not start new topics here, but here: New Panhead and Flathead topics
-
- Member
- Posts: 102
- Joined: Sat Apr 22, 2006 6:18 am
- Bikes: 04 Softail w/131
50 Pan
2011 Ultra
1998 Low Rider - Location: Toms River New Jersey
- Has thanked: 6 times
- Been thanked: 2 times
has anyone done a step by step
has anyone done a step by step pictorial on the reassembly of a panhead resto. finally getting ready to reassemble of my 50 pan and realized I don't remember all that I should have when taking apart. Been sitting too long
-
- Senior Member
- Posts: 2404
- Joined: Wed Jul 07, 2010 4:28 am
- Bikes: 1950Panhead
- Location: USA
- Has thanked: 1 time
- Been thanked: 366 times
Re: has anyone done a step by step
Tell us what your problems are and we will give you a hand.
Jerry
Jerry
-
- Member
- Posts: 102
- Joined: Sat Apr 22, 2006 6:18 am
- Bikes: 04 Softail w/131
50 Pan
2011 Ultra
1998 Low Rider - Location: Toms River New Jersey
- Has thanked: 6 times
- Been thanked: 2 times
Re: has anyone done a step by step
thanks guys got got the antique cycle supply and spare parts book, just got some cad plating to complete and still trying to decide on stainless spokes or re cad plating mine then I'm jumping in for the fall winter project. Got the motor done and all the parts for the trans just have to get the trans together. Had a lot of parts plated by pauls plating so finally getting my ass in gear
Re: has anyone done a step by step
I went with black powder coating on the rims and cad spokes.....looks good.
-
- Member
- Posts: 102
- Joined: Sat Apr 22, 2006 6:18 am
- Bikes: 04 Softail w/131
50 Pan
2011 Ultra
1998 Low Rider - Location: Toms River New Jersey
- Has thanked: 6 times
- Been thanked: 2 times
Re: has anyone done a step by step
thanks george
downloaded most of them but have printed out ones on most
downloaded most of them but have printed out ones on most