Internal Throttle Wire Gauge
-
- Member
- Posts: 98
- Joined: Sat Apr 09, 2016 12:59 pm
- Bikes: 1938 UL Harley-Davidson, 1955 FL Harley Davidson, 1965 FLH Harley Davidson
- Location: upstate New York
- Has thanked: 7 times
- Been thanked: 25 times
Re: Internal Throttle Wire Gauge
That wouldn't hurt either. I also use said graphite on the inner speedo cable, the spark advance cable where applicable, and a spritz on the cam lobe at the breaker points.
-
- Senior Member
- Posts: 1433
- Joined: Thu Mar 26, 2020 5:46 pm
- Bikes: Rigid Panhead bobber, 68 Shovelhead, 2000 Road King Police bike, 2000 Dyna Wide Glide
- Location: Rhode Island
- Has thanked: 997 times
- Been thanked: 711 times
Re: Internal Throttle Wire Gauge
Good point on speedo cable. I have a Dyna S ignition that retains the timer's centrifugal advance. I use the graphite on the weights where they pivot and where they engage the slots. Seems to work well so far.
-
- Member
- Posts: 78
- Joined: Wed Mar 21, 2007 5:48 pm
- Bikes: 1950 FL
- Location: Seattle
- Has thanked: 4 times
- Been thanked: 14 times
Re: Internal Throttle Wire Gauge
I am sorry I did not check this site more often. I see that you bought the wire from Granger, but need a longer length. I have glide bars. When I replace the wire, I basically follow the old wire out with the new wire. As I pull on the old wire, I shove the new wire in from the carburetor end. I use a light lithium grease on the new wire as I am inserting it. before I started doing it this way, I could not get the new wire through the spiral, it would catch somewhere. By following the old with the new, I haven't had to remove the bars, etc.