Should there be a washer between the nut and the triple tree?
Thanks,
Ran
Risers
-
- Member
- Posts: 378
- Joined: Mon Feb 06, 2012 9:16 am
- Bikes: 58FLH
- Has thanked: 55 times
- Been thanked: 29 times
-
- Former member
- Senior Member
- Posts: 3336
- Joined: Sat Jun 26, 2010 1:54 pm
- Bikes: 1958flh 1969sporty,had a knuckle but sold back to original owner
- Location: NEW JERSEY
- Has thanked: 195 times
- Been thanked: 278 times
Re: Risers
Noclass---my answer is yes!--I have put stainless flat washers on then the nut!---The stainless is not proper ,I think they were cad-plated ?--But yes a washer goes there.--If you try bolting-up without a washer ,--it dont look right!--Just my 2--Good-Luck---RICHIE/ PS---My manual shows the same pic. as yours!--soo-I went with what should be for correct tightening disperse.---