Tool Box and Mount

Post Reply
51Hog
Senior Member
Posts: 680
Joined: Fri Feb 25, 2005 1:53 am
Bikes: 1951 Fl
Location: Wasilla, Alaska
Has thanked: 1 time
Been thanked: 8 times

Tool Box and Mount

#1

Post by 51Hog »

Is this the correct tool box for the mount on this frame?
Is it right for a 51 FL?
I had it mounted, and vibrations fatigued the box parallel to the doubler that is up against the mount.
The lid is without ribs.
Thanks
You do not have the required permissions to view the files attached to this post.
Top
Robert Luland
Senior Member
Posts: 1036
Joined: Sun Sep 02, 2007 7:56 pm
Bikes: 1922 J, 1922 JD, 1937 ULH, 1946FL 1948FL, 1957FL, 1960FLH, 1965XLCH, 1995 FLHT
Location: Hoboken, NJ
Been thanked: 130 times
Contact:
Contact Robert Luland

#2

Post by Robert Luland »

It will fit any big twin but is not correct for 51. 58-64 is smooth cover. Bob
Top
51Hog
Senior Member
Posts: 680
Joined: Fri Feb 25, 2005 1:53 am
Bikes: 1951 Fl
Location: Wasilla, Alaska
Has thanked: 1 time
Been thanked: 8 times

#3

Post by 51Hog »

Thanks for the reply Robert.
My rear fender is drilled for the spacer. I think I will drill the box after welding the crack that runs full length of the doubler and install the spacer. Maybe it won't crack again.
Top
Post Reply

Return to “Fenders, Primary, Tanks & Paint”