I'VE GOT MY ORIGINAL 3.5 GAL. TANKS WITH FLAMES.
RIGHT SIDE TANK WORKS FINE, LEFT SIDE LEAKS DOWN AT THE
OUTER RIDGE ON BOTTOM SIDE OF TANK.
I'VE TAKEN THE TANK TO A BUNCH OF WELDERS, AND THEY ALL SAY
THEY CAN'T TRY WELDING THE SMALL CRACK WITHOUT DESTROYING THE PAINT JOB. THE CRACK IS ABOUT 1.5" FROM THE PAINT. i AIN'T GONNA SPEND A BUNCH OF $$$ TO REPAINT, BUT IT WOULD BE NICE TO HAVE TWO WORKING TANKS
I'VE TRIED THE USUAL STUFF, J-B WELD, KREEM, ET., STILL LEAKS.
ANYBODY HAVE ANY OTHER IDEAS?
THANKS
Gas tank leaking, how to repair
-
- Member
- Posts: 184
- Joined: Sun Aug 29, 2004 2:31 pm
- Bikes: 1948 FL 74in Panhead Chopper , 1958 Zundapp Citation 500
- Location: Indianapolis
- Been thanked: 1 time
gas tanks
Just do it with a wire welder (mig) in short spots with a wet rag right at the crack.Should be easy if the welder knows what hes doing. Flush the tank with water then with air for a couple minuets