I finally found a fender (ball and rail) fence for the back of my front fender. It came with the stud balls taped to the fence rail. I have 4 ball studs 2 with through holes and 2 end ball studs. Is there supposed to be a third through hole ball stud? I've always wanted one but also wanted to fill the hole that is in the rear center of my fender. When I bought the bike, it had a later model front fender with a mudflap mounted through the hole. The new fender I bought had the same hole. Was this for a mudflap or for fender trim? I'm looking for original options issued for a "59"
I am also wondering which fender light is correct for 59.
Can someone post pictures of these 2 items?
Fender fence installation
-
- Senior Member
- Posts: 953
- Joined: Tue Jan 08, 2008 12:32 am
- Bikes: 56 FLH, 2007 FLHRCI
- Location: Belleville, Ontario, Canada
- Has thanked: 49 times
- Been thanked: 28 times
-
- Senior Member
- Posts: 1500
- Joined: Wed May 09, 2001 11:02 pm
- Bikes: 50 EL chopper
44 U that looks like a 37.
60 FLH (Sold)
59 FLH (Sold)
58 FL (Sold)
08 CVO Road King - Location: Maryland
- Has thanked: 241 times
- Been thanked: 137 times
Does anyone have one stud they would sell? If I have to make it, I would make it out of stainless so I would probably have to make a set. the originals appear to be Cad plated or old chrome. They appear to be larger ball studs than the fence that was offered for the dash cover.
Last weekend I notice an aerosol can in my buddies shop on his bench. It was Cad paint. Has anyone seen this?
I could still use a picture for stud location purposes. Anyone?
Last weekend I notice an aerosol can in my buddies shop on his bench. It was Cad paint. Has anyone seen this?
I could still use a picture for stud location purposes. Anyone?