65 inner primary bearing

[65eglide]

Any tool out there to remove this bearing ?

[Cotten]

65eglide!

We assume the inner primary is dis-assembled, an upon the bench?

And we wish to replace the bearing and seal?

First I would pry or cut out the seal and discard it.

Then I would apply gentle heat, such as a heatlamp, hot air gun, or low propane torch to the casting around the bearing.

Please observe for any goobers that boil out from around it.

I then would explore, by attempting to tap the bearing out with an appropriate "puck", be it a large socket, or whatever.

If it resists, more observation is in order!

Please avoid hydraulic presses.

Let us know how it goes,...

...Cotten

[65eglide]

ya, primary is off,
I'll try that, just wasn't sure if a tool was available

[RUBONE]

The factory tool used to pull the hub, the inner primary, and the bearing is the same one, with different arrangements of bolts.

[65eglide]

ya that worked, heated a little popped right out