clutch installation

Post Reply
blewcrab
Member
Posts: 301
Joined: Mon Jul 09, 2012 11:08 pm
Bikes: 65FL and 2003 heritage
Location: Southern Maryland
Has thanked: 90 times
Been thanked: 41 times

clutch installation

#1

Post by blewcrab »

can someone post a picture of the clutch plate /with anti rattle balls. I have a set to install and the " OUT" is not marked on either side...I don't want to install backwards. Thanx in advance ,,Rick
Panacea
Senior Member
Posts: 2087
Joined: Fri May 24, 2002 1:00 am
Bikes: 64FL 99FLHR 01FXSTD
Location: Mpls. MN.
Has thanked: 72 times
Been thanked: 145 times

Re: clutch installation

#2

Post by Panacea »

http://www.ebay.com/itm/Alto-Products-S ... 020wt_1012" onclick="window.open(this.href);return false; You want the lugs in the clutch shell to "pull" on the solid side of the notch in the steel plates, not the "ball" side...Mike
58flh
Former member
Senior Member
Posts: 3332
Joined: Sat Jun 26, 2010 1:54 pm
Bikes: 1958flh 1969sporty,had a knuckle but sold back to original owner
Location: NEW JERSEY
Has thanked: 195 times
Been thanked: 277 times

Re: clutch installation

#3

Post by 58flh »

Install as Panacea said!--Make-sure the balls are loose & not rusted or fubared in some way!---Richie
blewcrab
Member
Posts: 301
Joined: Mon Jul 09, 2012 11:08 pm
Bikes: 65FL and 2003 heritage
Location: Southern Maryland
Has thanked: 90 times
Been thanked: 41 times

Re: clutch installation

#4

Post by blewcrab »

Thanx ! a picture is worth 1000 words !
Post Reply

Return to “Clutch & Mousetrap”