I rmoved my kick start cover today and found a cone shaped part postioned in front of the kick start ratchet gear. It looks likea small cone type clutch but doesn't appear in any of the books I've looked at.
Any ideas what it is and its purpose?
StueyC.
kick start
-
- Inactive member
- Member
- Posts: 201
- Joined: Sat Aug 01, 2009 3:48 am
- Bikes: 60 FL Pan, 2011 Wide Glide, 49 BSA, 40 Ariel, 47 Excelsior (British)
- Location: Australia
-
- Inactive member
- Member
- Posts: 201
- Joined: Sat Aug 01, 2009 3:48 am
- Bikes: 60 FL Pan, 2011 Wide Glide, 49 BSA, 40 Ariel, 47 Excelsior (British)
- Location: Australia
-
- Former member
- Senior Member
- Posts: 2789
- Joined: Tue Dec 18, 2007 2:10 pm
- Bikes: 1941/59 EL
1952 FL
1977 FLH
1994 Fatboy - Has thanked: 22 times
- Been thanked: 110 times
Re: kick start
There are some tricks in helping hold the throwout bearing in place when you reassemble. It can be pretty frustrating. One trick is to put the kicker cover flat on a table, open side up, and position the throwout bearing. Then remove the clutch pushrod from the transmission, use it as a 'holder' on the throwout bearing while you then re-attach the kicker cover, sliding the pushrod back in as you go.
The other trick I have only heard someone tell me, and have not used myself, so I'll save it for an ace-in-the-hole.
The other trick I have only heard someone tell me, and have not used myself, so I'll save it for an ace-in-the-hole.
-
- Inactive member
- Member
- Posts: 201
- Joined: Sat Aug 01, 2009 3:48 am
- Bikes: 60 FL Pan, 2011 Wide Glide, 49 BSA, 40 Ariel, 47 Excelsior (British)
- Location: Australia