4 speed tranny mounting plate

Post Reply
mikemacy
Junior Member
Posts: 8
Joined: Fri Feb 29, 2008 6:57 pm
Bikes: *

4 speed tranny mounting plate

#1

Post by mikemacy »

im not sure which way to mount this plate to the frame. does it mount with the cross member across the top or the bottom? also if you are looking at the mounting plate while standing at the rear tire is the cut off corner on the right side or left side?
thanks alot,
mike
Panacea
Senior Member
Posts: 2087
Joined: Fri May 24, 2002 1:00 am
Bikes: 64FL 99FLHR 01FXSTD
Location: Mpls. MN.
Has thanked: 72 times
Been thanked: 145 times

#2

Post by Panacea »

Cut off corner is on the left, I'm not sure what you mean in regard to the crossmember,The tranny plate mount (back of seatpost) is under the front end of the plate, and of course the rear of the plate sits on top of the two pipe lookin' bosses. Don't forget to check how flat the plate sits on the mounts, especially the fifth mount near the kicker,shim as needed. Mike
Post Reply

Return to “Transmission, Starter & Shifting”