Just rebuilt my 32E Generator and was wondering if there's a good starting point on the third brush setting?
Still going to be awhile before I start it. I just set it in the middle for know, I can try to check its output when I get her going.
32E third brush setting
-
Tudelum48
- Member
- Posts: 84
- Joined: Mon Nov 07, 2016 2:50 am
- Bikes: 1950 Harley Hydraglide
- Location: Punkin Ridge Kentucky
-
Bigincher
- Former member
- Senior Member
- Posts: 2789
- Joined: Tue Dec 18, 2007 2:10 pm
- Bikes: 1941/59 EL
1952 FL
1977 FLH
1994 Fatboy - Has thanked: 22 times
- Been thanked: 110 times
Re: 32E third brush setting
For an initial setting, it's better to be too low than too high.
If it was me, I'd put it around 1/3 until I got it dialed in.
If it was me, I'd put it around 1/3 until I got it dialed in.
-
Tudelum48
- Member
- Posts: 84
- Joined: Mon Nov 07, 2016 2:50 am
- Bikes: 1950 Harley Hydraglide
- Location: Punkin Ridge Kentucky