Cylinderheads
-
- Announcements
- Replies
- Views
- Last post
-
- Topics
- Replies
- Views
- Last post
-
-
Looking for heads for Panhead motor build
S&S Gen Alt cases with 4 1/4" Flywheelsby michigander52 » - 18 Replies
- 2193 Views
-
Last post by dragstews
-
-
- 28 Replies
- 1919 Views
-
Last post by 1962FLH
-
- 18 Replies
- 1842 Views
-
Last post by panhead
-
- 4 Replies
- 735 Views
-
Last post by Larry
-
- 45 Replies
- 5766 Views
-
Last post by Speeding Big Twin
-
- 10 Replies
- 1740 Views
-
Last post by RooDog
-
- 2 Replies
- 938 Views
-
Last post by Scrap
-
-
Valve stem seals loose on guides
Installed Sifton seals on machined valve guides. I can slip them right off the guides with my fingers.by Mongrel505558 » - 5 Replies
- 1877 Views
-
Last post by RooDog
-
-
- 2 Replies
- 704 Views
-
Last post by RooDog
-
- 13 Replies
- 8880 Views
-
Last post by awander
-
- 1 Replies
- 1060 Views
-
Last post by 48Doc
-
- 3 Replies
- 1472 Views
-
Last post by RooDog
-
- 4 Replies
- 1427 Views
-
Last post by theo
-
- 10 Replies
- 1452 Views
-
Last post by RUBONE
-
- 2 Replies
- 838 Views
-
Last post by awander
-
- 28 Replies
- 12760 Views
-
Last post by chadu607
-
-
Chip around valve guide
Need some advice and some opinions. Picked up a set of 48 heads yesterday there in good condition other then the front head has a spot around the valve guide that’s broken off. I’ve had a few people say run it and some say press the valve guide out and repair. Looking to see if any neon here has had th same issue. Thanks.by Bsimmons » - 3 Replies
- 1059 Views
-
Last post by Andygears
-
-
-
Picture heads 56-57 and 58-62
Does anybody have a clear picture where the difference between these heads can be seen?by theo » - 3 Replies
- 1232 Views
-
Last post by theo
-
-
- 18 Replies
- 5865 Views
-
Last post by RooDog
-
- 8 Replies
- 3024 Views
-
Last post by mik666