Panhead and Flathead site | Knowledge Base: Troubleshooting

:: Panhead and Flathead site ::

Panhead and Flathead site

Documentation / Information

Knowledge Base (Forum Archive)
	General(639)		Carburetor and Fuel System(349) - Linkert (212) - S&S (65)		Electrical System (528) - Generator		Transmission, Clutch, Belt and Chain (33) - Transmission, Starter & Shifting (436) - Clutch & Mousetrap (251) - Chains & Belts (109) - Sprockets (61)
	Troubleshooting (123)		Chassis & Frame (13) - Fenders, Primary, Tanks & Paint (429) - Frame & Fittings (300) - Handlebars & Cables (112) - Seat (118) - Speedometer, Dashboard & Instruments (112)		Forks and Shocks (232)		Accessories (154)
	Identification (71) - VIN / Cases / Heads (61) - Frame / Transmission (82)		Wheels & Tires (210)		Ignition and timing (386)
	Brakes (181)		Exhaust System (125)		Motor (156) - Bottom End, Crankcases (276) - Top End, Cylinders (393) - Cylinderheads (296) - Gear Case, Cams (156) - Lubrication System (425)

Troubleshooting: 123 topics

'48 starting problem

1951 Panhead HELP

1959 Duo kickstarting

1962 duo glide difficult to start from cold

56 FLH - Won't Idle

58 FLH wont start

58 running poorly

65 fl starting problems

65 FLH - timing and runnig issues....

65 pan smells gassy when running

A simple question, will not start when hot

Acceleration woes

Another Pan that won't start

Any advice on hot starting

Are belt primaries harder to kick

Back firing question

Backfiring through pipes.

BEEN THINKIN ABOUT THIS.....

Bike jerking issues CARB?...

Bike stalling after 2-4 miles riding

Bike won't start: the long story

Blowing white smoke

Broke down by the road

Can't get it started

Can't start it hot

carb problem with a 54 pan

cause of engine failure

Classic complaint... hard to start!

Could be the Clutch

Cut out while driving

Cylinder cutting out for about 30 seconds

Engine does not run hot

every time i fix somthin somthin else breaks

First time fired up

For my fellow riders in the World!

Fresh 1964 starting help

front cylinder rich....help diagnose!

Front-end wobble

gas in crankcase

Guess Pan Engine Problem

Hard Kicking Pan

Hard Starting 1958

hard starting 65 fl

Hard starting backfire

Hard starting or no starting

Hard starting when warm

Hearing a "clunk" from my motor

help: having problems getting it to run

Hesitation when I roll on the throttle

High Speed Wobble.

Hot start blues

I can't seem to get it to fire up after rebuild

Ignition or Carburetion?

Initial Live Kick Backfire

Kick backs: how do you deal with it

Kicking Pan with my Hands.....

Kickstart trying to hurt me

Lost compression 52 pan

Low rpm almost no load intermittent miss

Mechanical troubleshooting request

missing and popping out carb at high engine speed

Missing out, rough running new build

Motor stops running

needle bearing fragment in oil

no top end power

not wanting to start cold

not wanting to start cold

oil light on...?

One cylinder firing

One last time......I hope..

Overheating ???

PanHead cold and warm start

Panhead dies after 5 minutes

panhead hard to kick

Panhead just won't start

Panhead kick start help

Panhead lost spark

Panhead rear header pipe glowing orange

Panhead stops during run.

Please help get my 58' running, again

Rear cylinder not running right

Rear Steer Wobble

rebuilt 62 won't start!

Rough running 1957 FLH

Running on front cylinder only

running rich and hard starting 49 pan.

running right ?

Runs poorly when hot

Sifton/aftermarket cam chest gears

stalling while idling

Starting frustrations

starting problem 62 pan

Starting problems

Starting problems, impossible to kick start

Starting problems: I found some thing very interesting

Starts, but loss of power above idle

Strange noise... cannot find it

Throttle Response

Trouble starting 64 flh

Trouble starting hot -53 Pan

Trouble starting when hot

Vibrations: trying to smooth out the old bike

Where's That Button?

White smoke when hot

Won't stand up and run

Wont start, please help

Copyright © 2001-2023 Panhead/PTH