Most viewed |
Pepper red2080 viewsI got a sample of the original pepper red, and had it matched pretty close using a House of Colors chart, I have the bike apart but I'll try to load pictures.white1j0
|
|
swimmin2050 viewsAir does move both ways through the breather:
Out with warming up, and in with cooling down.
That's why you don't want to kill it in deep water.Cotten
|
|
The midget racer project motor2031 views30's midget racer powered by a 14 JDMP081
|
|
Front wheel cover, hub in place2028 viewsHub in place , not long now before shes off the table & on the roadknucko
|
|
|
Wire routing1984 viewsCourtesy of Matt Olsen: Matt Olsenpanhead
|
|
Wire routing 19491970 viewsHere is another great pic showing the neck and the gen. to switch wires. 49 was the only year that used two clips on the steering neck. The wiring on this bike is basically the same through 53 until hd came out with the trumpet horn.
Courtesy of Matt Olsen: Matt OlsenAnonymous
|
|
Wire routing1966 viewsHere is the shot that everybody needs to see. The Dash to coil terminal loom has never been removed from the bike judging from the original friction tape on the back bone. I am a little unsure about the wire loom being run outside of the triangle in the frame. I would personally run it through the triangle and into the coil terminal junction. Notice that the dash to gen. wire is taped to the downside of the frame, knuckleheads are taped to the right side.
Courtesy of Matt Olsen: Matt Olsenpanhead
|
|
|
Wire routing1929 viewsCheck out how tidy everything is, the speedo light has been removed.
Courtesy of Matt Olsen: Matt Olsenpanhead
|
|
Bump with a new pic I found of the bike from 1972 ! I think this is of the original owner from 48 year1913 viewsOLD WUN
|
|
Wire routing 19491905 viewsHere is a cool pic of the switch to Gen. wires, they are in clothe woven loom. The two relay wires and the relay wire on the generator go into some more clothe woven loom. This is a great pic, take notes. Check out the jam nut on the shift pivot bolt, the way the clutch pedal spider spring is, and the lack of a washer under the front case bolt. and lack of lock washers on the gen.
Courtesy of Matt Olsen: Matt Olsenpanhead
|
|
10552 files on 880 page(s) |
|
|
|
|
|
7 | |
|
|
|
|