:: Panhead and Flathead site ::

Panhead and Flathead Gallery

The Independent Panhead and Flathead Site Gallery

Home Contact Upload file Login
Forum Album list Last uploads Last comments Most viewed Top rated My Favorites By date Search
Most viewed
Entrace of the juneau plant2382 views"here's a pic of the original factory neon sign outside the entrance of the juneau plant. thought you guys might like to see if you've never been here.

I was here for work today. I thought you guys might like this. I hope its ok to post this here. it is the original sign on the original plant. :D"
1965 is a good year2324 viewsVisiting Rance4 commentsrmcrh
Front wheel cover, hub in place2022 viewsHub in place , not long now before shes off the table & on the roadknucko
Wire routing 19491969 viewsCheck out the asphalt loom that goes around the positive wire, and the two tail light wires.

Courtesy of Matt Olsen: Matt Olsen
1955 factory prototype cam cover1858 viewsjohn HD
Genuine 65 only PLASTIC solenoid cover #31444-651835 viewsGENUINE 65 only PLASTIC solenoid cover.UPSROD
Wire routing 19491827 viewsHere is another great pic showing the neck and the gen. to switch wires. 49 was the only year that used two clips on the steering neck. The wiring on this bike is basically the same through 53 until hd came out with the trumpet horn.

Courtesy of Matt Olsen: Matt Olsen
Wire routing1819 viewsCourtesy of Matt Olsen: Matt Olsenpanhead
Wire routing1813 viewsHere is the shot that everybody needs to see. The Dash to coil terminal loom has never been removed from the bike judging from the original friction tape on the back bone. I am a little unsure about the wire loom being run outside of the triangle in the frame. I would personally run it through the triangle and into the coil terminal junction. Notice that the dash to gen. wire is taped to the downside of the frame, knuckleheads are taped to the right side.

Courtesy of Matt Olsen: Matt Olsen
Wire routing1785 viewsCheck out how tidy everything is, the speedo light has been removed.

Courtesy of Matt Olsen: Matt Olsen
Oldtimers Rijswijk, 20121779 viewshydra74
Wire routing 19491773 viewsHere is a cool pic of the switch to Gen. wires, they are in clothe woven loom. The two relay wires and the relay wire on the generator go into some more clothe woven loom. This is a great pic, take notes. Check out the jam nut on the shift pivot bolt, the way the clutch pedal spider spring is, and the lack of a washer under the front case bolt. and lack of lock washers on the gen.

Courtesy of Matt Olsen: Matt Olsen
7979 files on 665 page(s) 2

Copyright © 2001-2020 Panhead/PTH