|
Is a linkers spacer necessary?28 viewsIs a linkert spacer necessary?flatheadDaveOct 05, 2019
|
|
Manifold leak test plate159 viewsOnly after reading multiple posts on this site and seeing the custom built manifold leak test plates that others had built, I decided to make one of my own since I have the carb off and replacing the throttle shaft bushings and replacing the brass float with a foam/ phenolic type material float that was put in the bike just before I bought it due to the fact that my bike seemed hard to get the settings just right at idle and would cough occasionally while at part-throttle and cruising 35-45mph. But anyhow this custom tool is a product coming straight from the help I've received here on this site. I took a 1/8" plate cut to basic outside carb flange dimension and traced the carb mounting gasket onto the plate with a sharp pick, center-punched and drilled 4 mounting holes and 1 for the 1/4 NPT fitting that I bolted the air pressure regulator that I took off my HVLP air spray gun, ran the air compressor and adjusted the regulator and found no leaks thankfully, so I thought I would share so others might use any of this info.PanheadBob58Jul 22, 2019
|
|
Linkert Article 1931460 viewsPhotos from an article in Indianapolis Sunday Star Nov 1 1932 regarding the founding of the Langsenkamp-Linkert Company.awanderAug 21, 2017
|
|
M81-A192 viewsLinkert M81AbrainheadSep 05, 2016
|
|
M81-A192 viewsLinkert M81AbrainheadSep 05, 2016
|
|
M81-A190 viewsLinkert M81AbrainheadSep 05, 2016
|
|
M81-A191 viewsLinkert M81AbrainheadSep 05, 2016
|
|
M81-A193 viewsLinkert M81AbrainheadSep 05, 2016
|
|
M81-A187 viewsLinkert M81AbrainheadAug 28, 2016
|
|
M81-A196 viewsLinkert M81AbrainheadAug 28, 2016
|
|
M81-A186 viewsLinkert M81AbrainheadAug 28, 2016
|
|
M74B208 viewsCottenMar 04, 2014
|
|
59 files on 5 page(s) |
2 | |
|
|