:: Panhead and Flathead site ::

Panhead and Flathead Gallery

The Independent Gallery for Panheads, Flatheads, Knuckleheads and others

Home Upload file Login
Panhead & Flathead Board Album list Last uploads Last comments Most viewed Top rated My Favorites By date Search
Home > Technical > Engine

oil filter mount790 viewsmade what I need . will do til I find the real thing . Cost 1 hour and approx 8 inchs scrap 1/2 rod. thanks for the suggestions and help, Thanks to bigincher for the accurate measurements.4 commentsjerrydJan 16, 2021
oil filter mount790 views1 commentsjerrydJan 16, 2021
Oil Filter Set Up903 viewsBuddhahoodvatolocoFeb 04, 2018
Serios Problem or easy to fix?359 viewscan the cast buschin be fixed if small leaking between case and steel?GomollJan 04, 2016
mechanical oil pump768 viewspage from early VL Riders HandbookFlatHeadSixOct 25, 2013
check1366 viewsoil tank surprisevipersniperSep 10, 2013
To Drill Heads Or Case (Oil Holes)443 viewsThe front cylinder gallery is toed in about 6 1/2", but these cases have extensive welding and re-decking, and the protractor isn't exactly precision. The galleries are a full 3/16", so I might have hogged them as well.CottenJul 16, 2011
Rear Cylinder Case Oil Hole929 viewsCottens original picture with intersection lines for reference.1 commentsCaptMikeJul 16, 2011
Rear Cylinder Case Oil Hole623 views5/32" by 2 5/16" deep; Looks like a nice even 67 degrees.
Drilling a single hole that cannot be seen is much simpler, and not nearly such a molestation.
CottenJul 15, 2011
finned covers for Panheads by ED Roth1732 viewschopperTonyNov 06, 2010
finned covers for Panheads by ED Roth743 viewschopperTonyNov 06, 2010
finned covers for Panheads by ED Roth652 viewschopperTonyNov 06, 2010
90 files on 8 page(s) 1

Copyright © 2001-2022 Panhead/PTH