Hi :
assembling thae 64 flh bottom end and I notice that there is quite a bit of clearance between the outside pinion shaft bearing washer and the 11007 retaining ring .
that tells me that the bearing itself could move the same amount ?
What is the proper clearance , I find .010 to.020 in the book but there is more than that .
Bruce Thompson
right case bearing washer clearance
-
- Senior Member
- Posts: 6937
- Joined: Sun Feb 10, 2002 2:30 am
- Bikes: -
- Location: Central Illinois
- Has thanked: 112 times
- Been thanked: 310 times
Re: right case bearing washer clearance
Bruak!
Do you have a washer on both sides of the cages?
....Cotten
Do you have a washer on both sides of the cages?
....Cotten
-
- Member
- Posts: 21
- Joined: Mon Feb 22, 2010 3:15 am
- Bikes: 1960 fl
1964 flh
1976 flh - Location: Canada
- Has thanked: 3 times
Re: right case bearing washer clearance
Hi Cotten :
yes its assembled as per the book , washer bearing ,bearing washer ,11007 retainer .
they are not stock hd washers , they mike out at .070 . I don,t have stock washer dimensions . is there different thicknesses of washer ?
Regards
Bruce
yes its assembled as per the book , washer bearing ,bearing washer ,11007 retainer .
they are not stock hd washers , they mike out at .070 . I don,t have stock washer dimensions . is there different thicknesses of washer ?
Regards
Bruce
-
- Member
- Posts: 21
- Joined: Mon Feb 22, 2010 3:15 am
- Bikes: 1960 fl
1964 flh
1976 flh - Location: Canada
- Has thanked: 3 times
Re: right case bearing washer clearance
The clearance is fine I finally use a feeler gauge behind the 11007 and the washer its .015 .