S@S billit oil pump installation

Lubrication System (oil feed pump and scavenger pump, reservoir, filter, and lines)
Post Reply
daddywags
Inactive member
Member
Posts: 12
Joined: Thu Dec 30, 2004 6:38 pm
Been thanked: 1 time

S@S billit oil pump installation

#1

Post by daddywags »

Hey, I am putting on a S@S billit oil pump with new pinion gear and breather gear for more oil flow, does anyone have the pages out of the Harley manual for installing the breather valve for shimming it up?
Thanks
fourthgear
Inactive member
Senior Member
Posts: 1400
Joined: Sat Apr 03, 2004 5:54 am
Bikes: -
Location: north florida
Been thanked: 7 times

#2

Post by fourthgear »

Breather gear end play , .001 - .005. in. Of course you will have to have the rear tappet guide off and cam out , reinstall gear case cover ,so you can get a feeler gage in there and I believe its a dry fit measurement .

Have you set your engine case up for there oil pump per S&S instructions ? You can down load them from S&S web sight, if not .
Post Reply

Return to “Lubrication System/Oil pump/Oil filter”