HES full flow pinion bushing
-
- Inactive member
- Junior Member
- Posts: 3
- Joined: Wed Jul 04, 2007 12:58 am
HES full flow pinion bushing
Has anybody ever used a full flow pinion bushing? I think they were manufactured by HES in So Calif. all they had was a groove cut in the pinion shaft bushing so that rather than oil being pumped into the pinion shaft once every revolution, the bottom end would get oil full time. Would there be any problem in running this system with a cast iron pump or would it require a larger volume pump, ie, aftermarket? I'd be interested in Jack Hester and Cotton's answers.