Cylinder Head Bolt Insert
-
- Inactive member
- Member
- Posts: 107
- Joined: Wed Nov 21, 2007 1:27 am
Cylinder Head Bolt Insert
Can heads be repaired if the insert for a head bolt has been pulled loose from the head. Not raised up from poor torquing procedure, but yanked like a tooth? Thanks for any advice.
-
- Senior Member
- Posts: 1014
- Joined: Fri Apr 18, 2003 12:26 pm
- Bikes: *
- Location: Sultan, WASH
- Been thanked: 6 times
- Contact:
Re: Cylinder Head Bolt Insert
yes they can, the old insert is milled out and retaped for a insert that is screwed in and then a expander bolt is threaded into the new insert and it swells the OD of the insert out into the head, kinda like the ones STD and S&S use in there heads, had it done on my old head that was cracked right thru the old insert, it had to go to be welded properly....
mbskeam
mbskeam