cylinder gasket surfaces
-
- Inactive member
- Senior Member
- Posts: 1401
- Joined: Sat Apr 03, 2004 5:54 am
- Bikes: -
- Location: north florida
- Been thanked: 7 times
cylinder gasket surfaces
My 65 ,cylinders, head & base gasket surfaces have slight pitting on them , I read here that some one put there's on a lathe and turned them down , is that the method to clean them up ?( I 'm no machinist , out of my league ) They don't need much ,but more than a cleaning will take care of . I like clean, true gasket surfaces and we all know they can make or break a good seal .
-
- Inactive member
- Senior Member
- Posts: 1401
- Joined: Sat Apr 03, 2004 5:54 am
- Bikes: -
- Location: north florida
- Been thanked: 7 times