WTB Panhead front cylinder

Top End (cylinders pushrods etc.)
Post Reply
cdndewey
Member
Posts: 399
Joined: Thu Feb 21, 2008 9:07 am
Bikes: 42 WLC, 47 EL, 53 FLE, 62 FL, 78 FLH
Location: British Columbia
Has thanked: 1 time
Been thanked: 20 times

WTB Panhead front cylinder

#1

Post by cdndewey »

I'm looking for a 53-62 front cylinder 30 thou over or less. I have two rears, one at 10 over and one at 30 over, so as close to standard bore the better, so I can use the 10 over.

I couldn't figure out how to put this in the classified section, so it ended up here.
1950Panhead
Senior Member
Posts: 2404
Joined: Wed Jul 07, 2010 4:28 am
Bikes: 1950Panhead
Location: USA
Has thanked: 1 time
Been thanked: 366 times

Re: WTB Panhead front cylinder

#2

Post by 1950Panhead »

Pair of 55 cylinders.
http://www.ebay.com/itm/HARLEY-PANHEAD- ... e1&vxp=mtr" onclick="window.open(this.href);return false;
Cotten
Senior Member
Posts: 6937
Joined: Sun Feb 10, 2002 2:30 am
Bikes: -
Location: Central Illinois
Has thanked: 112 times
Been thanked: 310 times

Re: WTB Panhead front cylinder

#3

Post by Cotten »

Cdndewey!

It is a waste to bore any life out of any cylinder just to make it match;
The motor really does not care if they match or not.

....Cotten
cdndewey
Member
Posts: 399
Joined: Thu Feb 21, 2008 9:07 am
Bikes: 42 WLC, 47 EL, 53 FLE, 62 FL, 78 FLH
Location: British Columbia
Has thanked: 1 time
Been thanked: 20 times

Re: WTB Panhead front cylinder

#4

Post by cdndewey »

Cotten wrote:Cdndewey!

It is a waste to bore any life out of any cylinder just to make it match;
The motor really does not care if they match or not.

....Cotten
I hadn't planned on doing that. I'd just like to find something close in size to either of the rear cylinders that I have.
Cotten
Senior Member
Posts: 6937
Joined: Sun Feb 10, 2002 2:30 am
Bikes: -
Location: Central Illinois
Has thanked: 112 times
Been thanked: 310 times

Re: WTB Panhead front cylinder

#5

Post by Cotten »

Cdndewey!

You may not want to dismiss a .040" or .050" front cylinder then...


....Cotten
cdndewey
Member
Posts: 399
Joined: Thu Feb 21, 2008 9:07 am
Bikes: 42 WLC, 47 EL, 53 FLE, 62 FL, 78 FLH
Location: British Columbia
Has thanked: 1 time
Been thanked: 20 times

Re: WTB Panhead front cylinder

#6

Post by cdndewey »

Cotten wrote:Cdndewey!

You may not want to dismiss a .040" or .050" front cylinder then...


....Cotten
I won't....but I would like something close to what I have. I have a couple years before this pan sees the road so seek I shall.
Post Reply

Return to “Top End / Cylinders / Pushrods / Lifters”