dialing in linkert
-
- Inactive member
- Member
- Posts: 34
- Joined: Sat May 05, 2007 12:54 pm
- Location: Iowa
dialing in linkert
i am real close to having this where i want it butttttt,starts good ,idles good ,runs through the gears good. running along bout 65 let off throttle and get back into it it wants to crap somewhat, not pop through the carb, but acts like its loading -up.should i lean up the high side another click or two or the low side. just how much differernce can a click or two make. got home and pulled the plugs, both have a nice tan apperance. just where does the low speed stop and the high speed take over. got the intake tester from mike and yes did have a bad one. replaced both and put on good wrap within clamps, finger tight and then snugged up about 2 turns each. i am open for suggestions please, thanks -dick
-
- Senior Member
- Posts: 6937
- Joined: Sun Feb 10, 2002 2:30 am
- Bikes: -
- Location: Central Illinois
- Has thanked: 112 times
- Been thanked: 310 times
Re: dialing in linkert
Dick!
If "wrap" means some sort of tape, my suggestion is remove it and clean away any adhesive thoroughly.
Good luck,
....Cotten
If "wrap" means some sort of tape, my suggestion is remove it and clean away any adhesive thoroughly.
Good luck,
....Cotten
-
- Inactive member
- Member
- Posts: 34
- Joined: Sat May 05, 2007 12:54 pm
- Location: Iowa
Re: dialing in linkert
by wrap around i mean the clamp itself. it wraps within itself like a hose clamp. had the grooved clamps on before and i think it cut the o-ring so i thought i would try these-dick
-
- Inactive member
- Member
- Posts: 34
- Joined: Sat May 05, 2007 12:54 pm
- Location: Iowa
-
- Senior Member
- Posts: 534
- Joined: Tue Apr 21, 2009 4:20 pm
- Bikes: Two Schwinns, a Hercules, and a Hiawatha
- Location: Underground in Illinois
- Has thanked: 3 times
- Been thanked: 6 times
Re: dialing in linkert
Dear Dick,
Did you bubble test after you put it back together? Did you bubble test the pan cover screws above the clamps? Sometimes they get poked into the port.
'Spectful,
Did you bubble test after you put it back together? Did you bubble test the pan cover screws above the clamps? Sometimes they get poked into the port.
'Spectful,
-
- Inactive member
- Member
- Posts: 34
- Joined: Sat May 05, 2007 12:54 pm
- Location: Iowa
Re: dialing in linkert
only does it when i open up the throttle while going down the road. doesn't miss a bit if sitting in driveway and crack the throttle
-
- Inactive member
- Member
- Posts: 34
- Joined: Sat May 05, 2007 12:54 pm
- Location: Iowa